Nowadays, more and more construction sites will use a kind of construction equipment called pile driver. Its moderate price, high efficiency, and labor saving are welcomed by the market. As a construction site pile driver manufacturer, I would like to remind you that everyone should keep in mind the basic matters when operating the pile driver to avoid accidents. The operation of the pile driver should be carried out in accordance with the process specifications, and there are also operating specifications for the installation of the pile driver. The following takes the crawler pile driver as an example to explain the installation specifications. The pile-driving arm manufacturer recommends that you choose a flat and strong place for installation. If the foundation bearing capacity of the place does not meet the specified requirements, lay a roadbed box or a steel plate with a thickness of not less than 30mm, a roadbed box or a steel plate under the crawler. The spacing cannot exceed 30mm.

Observe whether it emits blue smoke. Blue smoke is a distinctive feature of burning engine oil. Whether it is maintained on time and whether the authentic diesel filter element is used.

Whether the pile driver uses high-quality diesel oil. If the quality of diesel is poor, it will cause serious burnt carbon deposits in the cylinder, leading to wear of the piston ring and cylinder barrel. After the gap is too large, the oil is burned in the combustion chamber, resulting in oil consumption. Is there too much oil? The engine of the pile driver is not tight enough to cause oil leakage. Observe the phenomenon that the pile driver burns oil and there is oil dripping in the lower exhaust. These details affect its service life and allow you to invest in the price of the pile driver on the construction site and get the greater use of benefits.

In addition, the piling arm manufacturer warmly reminds that when the temperature is very high, the method of deflation and pressure reduction cannot be used, and the tires cannot be cooled with water to avoid accelerated damage to the tires. Park and rest in a cool place, and continue construction after the tire temperature drops. The fifth is to avoid storing wheeled road pile driver tires near sunlight, oils, acidic substances, flammable substances and chemically corrosive substances.

The construction site piling machine manufacturer has proposed a simple method that can guarantee the shape of the guardrail: first, use a level to measure the cross line of each column position (no leveling point is required, only the relative elevation is measured), and based on these data Calculate the slope, the algorithm is as follows: suppose that the height of n piles is measured by a level once, and the height of n piles is subtracted from the number, and the obtained value is divided by (n-), and the column height at each position is 70cm, the second position The column height minus the column height at the second position, and then minus 70cm is the column height to be obtained. The column heights at the 4 positions can be deduced by analogy. Use a red pencil to mark the penetration depth on each column to be driven into.